HYF1001.1 series control board can be embedded in various aviation obstacle lights, beacon lights, airport navigation lights, apron perimeter lights, solar ship lights, solar warning lights, etc., to better display the outline of the structure, so that aircraft operators can judge the height and outline of the obstacle, and play a more intuitive and effective reminder of the warning effect.
Features
- It can support 3 channels of simultaneous output, and the output current of each channel can reach 1.5A.
- It can be connected to the anode board for charging, and the charging current can be up to 3 A. The standby current is as low as 180uA.
- Reserve photosensitive sensor interface, you can choose solar panel or photosensitive for light control.
- Reserve 12 hours or 24 hours selection interface, you can choose to light up only at night or 24 hours.
- There are 9 lighting modes available: Constant On (default), Alternating Dual-Channel Strobe, 4-second On-Off Cycle, 10-second Long Flash Cycle, 4-second Single Flash Cycle, 6-second Double Flash Cycle, 15-second Morse Code Cycle, 1-second Continuous Fast Flash Cycle, and 0.5-second Continuous Very Fast Flash Cycle.
- Wide supply voltage (3.2V-20V), typical supply voltage values of 3.2V, 3.7V, 6V, 7.4V, 11.1V, 12V can be used.
- Burn-in interface is reserved for customization.
Solar-powered navigation light control board, solar-powered aviation obstruction light controller, with 9 lighting modes to choose from and an ultra-wide operating voltage range of 3.2V–20V.
Applications
Aviation obstruction lights (with photosensitive interface), beacon lights (with photosensitive interface), airport navigational aids, apron boundary lights, solar ship lights, solar warning lights and so on.
